[Frameworks] eiki slimline slotload

From: ev petrol (email suppressed)
Date: Sun Jun 13 2010 - 13:08:27 PDT


hey all

this might be a bit of a daft question, but just in case ...
was removing a looper from an eiki slimline slotload & found a small spring when i was cleaning up, which i'm presuming escaped from the projector, but can't see anywhere obvious it should go ... it's about 3cm long & 5mm wide;
was unscrewing the looper from where the handle normally goes, so i'm guessing it should go somewhere in the vicinity ...

& if anyone's in dublin, we've a new solus expo coming up at filmbase! opening on june 24th, with a coupla screenings the following week

cheers all round, moira

www.moiratierney.net

      


_______________________________________________
FrameWorks mailing list
email suppressed
http://mailman-mail5.webfaction.com/listinfo/frameworks