From: Patricia R. Zimmermann (email suppressed)
Date: Wed Nov 18 2009 - 05:38:31 PST
All of the works by LES LEVEQUE fit this category.
-------
Patricia R. Zimmermann, Ph.D.
Professor, Cinema, Photography and Media Arts
Roy H. Park School of Communications
Codirector, Finger Lakes Environmental Film Festival
Division of Interdisciplinary and International Studies
953 Danby Road
Ithaca College
Ithaca, New York 14850 USA
Office: +1 (607) 274 3431
FAX: +1 (607) 274 7078
http://faculty.ithaca.edu/patty/
http://www.ithaca.edu/fleff
BLOG: http://www.ithaca.edu/fleff10/blogs/open_spaces/
email suppressed
---- Original message ----
>Date: Wed, 18 Nov 2009 08:13:39 -0500
>From: Experimental Film Discussion List <email suppressed>)
>Subject: Remake, reconstruction, interpretation
>To: email suppressed
>
>i'm seeking short experimental films based on original films either as remakes, reconstructions, or interpretations for a film festival in France in March 2010. Please post your suggestions/recommendations, or respond directly to my e-mail at The Cleveland Institute of Art.
>
>BRUCE CHECEFSKY | Director, Reinberger Galleries
>Voice: 216-421-7407 | email suppressed
>The Cleveland Institute of Art | 11141 East Boulevard, Cleveland, OH 44106
>
>________________________________________
>From: Experimental Film Discussion List [email suppressed]
>Sent: Wednesday, November 18, 2009 7:01 AM
>To: email suppressed
>Subject: Re: xenon 16mm projector in Florida?
>
>Hi Jeff,
>thanks for the info.
>I have both kinds of loopers (and the motorized one runs on 110V).
>I will check out your links.
>But there are frameworkers in Florida, including the festival at Gainesville where Roger Beebe shows 16mm. I know, because I was there last February 22!
>Maybe someone down there will be willing to rent one!
>All the best,
>Pip
>
>
>
>At 4:25 -0600 18/11/09, Jeff Kreines wrote:
>Does your looper use a motor, Pip? Or is it just driven by the film? You may need to deal with 110v/60Hz power.
>
>You might try the lab in Miami -- Cineworks -- http://www.cineworks.com/?page_id=213 -- while they don't make prints they may know the local rental availabilities. 16mm projectors are getting hard to find.
>
>International Cinema may rent machines, but they can be difficult to deal with. http://www.iceco.com/
>
>Good luck!<http://www.iceco.com/>
>
>__________________________________________________________________ For info on FrameWorks, contact Pip Chodorov at <email suppressed>.
>
>
>__________________________________________________________________
>For info on FrameWorks, contact Pip Chodorov at <email suppressed>.
__________________________________________________________________
For info on FrameWorks, contact Pip Chodorov at <email suppressed>.